4.2.
Acceptable environmental conditions
In detail, the conditions of the room where easyWallbox is sited must
be as follows:
⚫ room temperature between -25°C and +50°C
⚫ average temperature over 24 hrs less than 35°C
⚫ maximum altitude above sea level: 2,000 metres
⚫ relative air humidity not higher than 95%
4.3.
What’s inside
Take the following into consideration when choosing the position for
th
e
installation
of
e
as
yW
allbo
x
:
⚫ avoid exposure to direct sunlight, if necessary, by installing a canopy
⚫ avoid direct exposure to the rain so that deterioration due to bad
weather does not occur
⚫ ensure sufficient ventilation for the device – do not mount it inside
a niche or a closet
⚫
avoid an accumulation of heat - keep the device away from heat
sources
⚫ avoid exposure to water infiltration
⚫ avoid excessive leaps in temperature
easyWallbox
package contains:
e
as
yW
allbo
x
,
in
c
ludin
g
cables,
power supply plug and
charging connector
Current sensor for Dynamic
Power Management (DPM)
Drilling template
3 screws
3 fixing Plugs
Manuals and product
certificate
Damage to easyWallbox caused by unsuitable environmental
conditions.
Inappropriate positioning of easyWallbox may cause damage
to the device.
Danger of fire and explosion
easyWallbox must be installed in areas where there are no
incendiary or explosive substances, such as close to petrol
stations, because any sparks triggered by its components could
cause fires or explosions.
Do not stack loads on the box containing easyWallbox and pay
attention to the signs and specific instructions on the package.
To Next Page
Loading...
