ENGIE EPS easyWallbox - Package Opening Procedure; Wall Mounting Procedure

GB
GB
22
23
4.4. Opening the package 4.5. Wall mounting
Closed box containing
easyWallbox
Opening the lid of the box
containing easyWallbox
Raising the panel
in the box with easyWallbox
Drill
Pencil
Screwdriver
Hammer
Spirit level
Measure tape
tools not included
When the box is opened, check that the various parts of easyWallbox
do not show signs of physical damage caused by knocks, lacerations
or abrasions. If damage is detected, installation must be interrupted
immediately and the type of damage reported to the seller. If necessary,
contact assistance as explained in 11.
The individual components of the device are protected by PVC
packaging and sealed with adhesive tape. When the box is opened, the
parts should be cleaned to remove any dust, PVC residues or portions
of adhesive tape.
easyWallbox must only be taken from the box when everything has
been prepared for the installation and it must be transported manually
to the wall chosen for its installation.
The national and international building regulations and the directives
defined by the International Electrotechnical Commission IEC 60364-1
and IEC 60364-5-52 must be respected when fixing easyWallbox to the
wall. Correct positioning of the charging station is important for its operation.
When the installation wall is chosen for easyWallbox, take the distances
of the connection to the power supply and the connector on the vehicle
into consideration as well as the parking and manoeuvring space
available.
If several easyWallboxes are installed close together, there must be at
least 20 cm between each one.
easyWallbox must be installed at a height of 1.30-1.40 m from the floor.
Risk of electric shock.
Before starting installation, ensure that the easyWallbox is not
connected to any power supply. Any installation, maintenance and
dismantling operation should only be done when the power supply is
switched off on your service panel.
ENGIE Eps declines any liability for damage to persons or things
that may arise from the use of such tools. We recommend
contacting qualified personnel or service for any questions or
doubts concerning easyWallbox installation.
1
1
2
2
3
3
4
4
6
6
5
5
When easyWallbox is moved manually, do not trip on the power
supply cable of the vehicle.
1
2
3
4
5
6