Page 14
Omniguard Cellular™ Owner’s Manual
Page 15
Engineering Solutions Inc
Printer Settings & Reports Screen
The Omniguard maintains a log of all recorded data, alarm messages
and changes in operational settings. The current Job or any previous
Job (or portions of those jobs) and the Omniguard’s Configuration
Report can be viewed or printed at any time.
To uch th e p rin ter ic on
at the Home screen to go to the Printer
Settings & Reports screen.
Note: If a printer error is detected, the printer
stops automatically and the printer Jammed
icon appears. Touch the Jammed icon to view
instructions on how to remove jammed paper.
Once the jam is cleared, you will need to go to the
printer settings screen to turn on the printer. Printer
jams are logged with a time-stamp.
Note: The icon indicates that the printer is disabled
while it is powered by the battery. Plug the AC
cord of the Omniguard into an electrical outlet to
re-enable the printer.
To view or print the current Job Log --
1. Touch the
icon at the Home screen.
2. Touch the Job Name & Duration (white text) to change the report’s
duration, then touch Print or View.
3. Scroll thru the report using the arrows (if viewing).
4. Touch to return to the Home screen.
To view or print a previous Job Log or the Confi guration Report --
1. From the Printer Settings screen, touch Other Report/Log. Use
the arrows to scroll through the available reports & logs. Tap the
Name of the report to view it or print it.
2. The selected item will appear on the screen to view, use the arrows
to scroll thru the report. Touch Print at any time to print it.
Cancel printing by touching anywhere on the screen.
General Settings Screen
In the General Settings screen the following can be set:
- Contractor Name
- Time & Date
- Log Rates
To g o to the General Settings screen t ouch the
icon in the upper
left-hand corner of the Home screen, then touch General Settings.
Contractor Name: The Omniguard can store the name of the Contractor
that is using the unit. The Contractor Name is shown in all Job logs
and printed reports. Only one name can be stored.
To set the Contractor Name --
1. Go to the General Settings screen from the Home screen as
described above.
2. To the right of Contractor Name will be “Your Name” or the
previously entered contractor name in white text.
3. Touch “Your Name” and the Keyboard screen will appear.
4. Use the alpha-numeric keyboard to enter the contractor name.
5. When the entire name has been entered, touch
to return to
the previous screen. The new contractor name will be shown.
To uch
to return to the Main Menu.
Time & Date: The time and date are used as a reference time-stamp
for all logged events.
To change the Time & Date --
1. Go to the General Settings screen by touching the icon in
the Home screen, then touch General Settings.
2. Touch the arrows to adjust the time minute by minute. Hold the
arrow to increase the speed of adjustment.
3. To set the date, simply touch the white text indicating the month,
Example of Typical Job Log Printout
Typical startup sequence
Setting changes print for verification
Containment pressure reached
operating window... status is NORMAL
Alarm Condition (Alarm 1 tripped)
Back into NORMAL operation
New Date prints at midnight
Sign-off header
To Next Page
Loading...
