Engineering Solutions OMNIGUARD 5 - Wifi Communication Set up and Operation

Page 22
Omniguard Cellular™ Owner’s Manual
Page 23
Engineering Solutions Inc
4) Press Option to choose which type of Status Updates
will be emailed. Touch the box to select. Status
Update emails have the Status Message + Job Name
+ Omniguard Serial Number in the email Subject. This
allows receiving personnel to easily automatically sort
incoming emails into appropriate inboxes.
a. Power Status
b. Waiting for pressure (every 60 min)
c. Alarms and Alarm Updates (every 15 min)
d. Normal Operation Updates (every 60 min)
5) Touch to choose when the 24 Hour Job Log will be
sent.
6) Touch
to return to the Cellular Communication screen.
Touch
again to return to Home Screen.
press Connect to connect your Omniguard’s cell modem to the
network, or you can press
to skip connecting to the cellular
network.
To set up Cellular Communication
1) From the Home Screen, touch to go to the Network
Communication screen.
2) The network status is in the top left corner of the screen.
Touch Off to toggle through the Network options untill you
reach Cellular.
3) On the top right corner of the screen, Initializing... is
displayed while attempting to connect to the Verizon
cellular network. When connected the Signal strength
percentage will display.
5) Touch
to return to the Cellular Communication screen.
Touch
again to return to Home Screen.
WiFi Communication Set Up and Operation
The Omniguard Cellular has a built in Wifi Module that will that will
automatically send status report updates (including Power, Alarm,
Normal Operation and Job Logs) to off-site personnel via cell phone
text messaging and email. 24 Hour Job Logs are sent on a daily
basis, eliminating the need to visit the job site to manually download
logs. Job Logs are received via email as an attachment and can be
viewed with any text editor.
To set up WiFi Communication
1) From the Home Screen, touch to go to the Network
Communication screen.
2) The network status is in the top left corner of the screen. Touch
Off to toggle through the Network options untill you reach WiFi
or WiFi+
3) To enter the Wifi Network information, press the WiFi button in the
lower left hand corner. You will need to enter the Network Name
and Password to connect to the local Wifi network.
4) On the top right corner of the screen, Initializing... is
displayed while attempting to connect to the WiFi network.
When connected the Signal strength percentage will
display.
5) Touch
to return to the Cellular Communication screen.
Touch
again to return to Home Screen.
Entering Contact information for Remote Communication Recipients
To send text messages to Cell Phones, use the 10
digit wireless number without dashes combined
with the domain for the phones’s network to create
an email address as shown below.
Domains for major wireless network providers are listed
below. Domains for networks not shown can be found online.
Alltel Wireless @sms.alltelwireless.com
AT&T Wireless @txt.att.net
Boost Mobile @myboostmobile.com
Consumer Cellular @txt.att.net
Cricket @sms.mycricket.com
Metro PCS @mymetropcs.com
Sprint (PCS) @messaging.sprintpcs.com
@pm.sprintpcs.com
Sprint (Nextel) @page.nextel.com
Straight Talk @vtext.com
T-Mobile @tmomail.net
US Cellular @email.uscc.net
Verizon @vtext.com
Verizon @vtext.com
Virgin Mobile @vmobl.com
1) From the Network Communication Screen, enter an
E-mail Address (or Cell Phone Number texting address)
plus an optional Name for up to 4 personnel to be
remotely notified.
2) Check the boxes to the left of the Email Address for each
email address to receive Status Updates or Job Logs or
both.
3) Press Test to send emails, confirm emails were received
by all personnel listed. Test emails have the Subject:
‘Testing