Doc.-ID: ENS_13062019-EN
Preface
Dear Customer,
Thank you for selecting ENSITU
®
7000 as your InSitu flue gas oxygen analyzer.
Since 1980 our analyzer systems have been operating in numerous applications with tens of thousands
of units being produced and shipped worldwide. ENOTEC is committed to absolute quality and
performance and over time we have continuously enhanced our products to integrate various features
and functions.
ENOTEC probes include the zirconium oxide sensor which has a gas-tight seal made by using a special
process and technique developed by ENOTEC. This leads to a considerably increased service life
compared to "glued or cemented" sensors that have a tendency to leak or crack during operation.
All ENOTEC instruments are thoroughly tested in the factory and are subject to a strict ISO9001 Quality
Assurance Procedure. Therefore, with the correct installation, the operation of the ENSITU
®
7000 is very
straightforward and user friendly and will provide many years of trouble free operation with perfect
measuring results.
Symbols used in this Manual
Warning
Follow all instructions in the manual
Consider Information
Points out important information which
must be considered before execution
Warning hot surface
Warns of danger of burns which could
occur from hot system parts
Note
Contains further detailed information
Attention
Warns of risks by destroying the system
or its components or its functionality
Ground earth electrical protection
The contents of this manual are protected by copyright. Alterations and errors reserved.
Safety Instruction
After removal of terminal covers some parts of this system may be accessible which are under voltage.
Only well trained and authorized personnel are allowed to work on this system. The personnel must
know and understand all precautions, safety, installation and maintenance instructions of this manual.
The trouble free and safe operation of the ENSITU
®
7000 requires safe transportation, professional
storage, installation, operation and maintenance.
Furthermore all local safety and legal requirements at the point of installation and operation must be
considered.
The ENSITU
®
7000 may not be used to measure oxygen in combustible gases or in an environment
with combustible gases as the heated sensor may cause an explosion risk.
To Next Page
Loading...
