Installation and Operation Manual - ENSITU
®
7000
System Description
Doc.-ID: ENS_13062019-EN 5
1.5 Disruption of the Process
The analyzer system has to be kept in operation also in the event of the process being
disrupted or if the plant is powered off temporarily (e.g. at night or during the weekend).
Frequently cooling down and heating up of the probe results in thermal stress of the hot probe
parts (heater, thermocouple and sensor) and reduces their product life. ENOTEC will not accept
any responsibility for resultant damage.
1.6 Storage instructions
ENOTEC equipment and spares are to be stored in a dry and ventilated environment. Paint
fumes, silicone sprays, etc. must be avoided in the storage environment.
1.7 Name Plates
The name plate contains information about the voltage, the nominated current, frequency,
protection class and serial number. The serial number refers to information which is detailed in
the system test report and supplied with the system.
Electronics name plate Probe name plate
Figure 3 – Position of the name plates
To Next Page
Loading...
Need help?
General
