Software Release: [App: 02.09.10051.00; Config: 2.9.20024; Built in PowerVision Configuration Studio Version: 2.9.23042;
BTL: 02.09.10015.00]
Section 40 50 00-02-0939
2019-06-13
Communication Mapping
This section outlines the RS485 Modbus Register Map and CAN Parameter Map.
MPC-10 & TEC-10 RS485 Modbus Registers
NOTE: The registers labeled Read/Write will allow the operator to change values through the
Modbus as a temporary modification. If power is cycled to the MPC-10 / TEC-10, the values
changed via Modbus will revert back to the last value entered locally. Writing a 1 to register
40240 will allow saving register changes to controller.
Current Engine Hours (32 Bit)
System Voltage (12.5 will read 125)
Actual Engine Oil Pressure
Actual Engine Temperature
Controller State (Active State: Numeral Indicated)
2 = Controller in Standby
13 = Running Cooldown Delay
14 = Energize to Stop Delay
15 = Engine Spindown Delay
Active Shutdown Status (Active Fault: Bit = 1, Inactive: Bit = 0)
6 = Low Discharge Pressure SD
7 = High Discharge Pressure SD
11 = Fuel Filter Restriction SD
To Next Page
Loading...
Need help?
General
