Software Release: [App: 02.09.10051.00; Config: 2.9.20024; Built in PowerVision Configuration Studio Version: 2.9.23042;
BTL: 02.09.10015.00]
Section 40 62 00-02-0939
2019-06-13
TEC-10 Specifications
Interface
Display:
Monochrome HR-TFT, 2.7 in. / 68mm, WQVGA (400 x 240 pixels)
(3) LEDs: green (mode), yellow (warning) and red (shutdown)
Operator controls:
(11) Raised silicon keypads, tactile feedback
(1) Keyed Rotary switch, power on/off
(1) Push-switch (red), engine stop
Power Supply
Operating Voltage: 8-32 VDC, reverse battery polarity and load-dump protected
Cranking Power Holdup: 0 VDC up to 50mS (also good for brownout/blackout instances)
Power Consumption:
Power on in stopped state; 117 mA at 12 VDC,
Power on in standby mode; 52 mA at 12 VDC
Inputs
(5) Digital, configurable (active on High, Low, Open)
(3) Analog, configurable (4-20mA, 0-5V, resistive or digital ground)
(1) Frequency, supporting:
Magnetic Pickup (30 Hz – 10 kHz, 2.0 VAC – 120 VAC) &
Engine Alternator (30 Hz – 10 kHz, 4.5 VRMS – 90 VRMS)
Outputs
(2) Relay, switched +DC, 10A
(1) Relay, Form C (dry / volt-free), 10A
(2) Low-side FET (-DC), 1A
(2) High-side FET (+DC), 1A
(1) Dedicated Alternator Excitation, +DC, 1A
Communications
(1) CAN: J1939
(1) RS485: Modbus RTU
Mating Connectors
21 Position, Deutsch HDP26-24-21SE,
31 Position, Deutsch HDP26-24-31SE
Physical / Environmental
Enclosure Material: Polycarbonate / ABS
Dimensions (WxHxD): 9.59 x 7.34 x 5.20 in. (243.48 x 186.5 x 132.23 mm)
Weight: 4 lbs (1.8 kg)
IP Rating: IP67
Operating & Storage Temperature: -40° to +85° C (-40° to +185° F)
Vibration: 7.86 Grms (5-2000 Hz), 3-axis random
Shock: ±50G, 3 axis
Emissions & Immunity: SAE J1113, 2014/30/EU & 2014/35/EU
To Next Page
Loading...