enphase IQ System Controller 3M - Addendum B: Wiring the System Bonding Jumper Wire

38
IQ System Controller 3M quick install guide IQ System Controller 3M quick install guide
Addendum B: Wiring the system bonding jumper wire
The IQ System Controller 3M is typically not used as a service entrance.
However, If the IQ System Controller 3M is being tapped on the grid side of the main panel, then,
1. Connect a suitable system-bonding jumper between the neutral and ground bars.
2. Paste labels provided in the accessory kit.
Grounding Electrode Terminal
Grounding Electrode Terminal
Main/Service Disconnect
Suitable for use as Service Equipment
Magnied view
Main/Service Disconnect
Suitable for use as Service Equipment
Label
Label