11
Electrical connection
Note!
The installation shall be made according to local codes.
During any work with the electrical connections the mains must be disconnected.
•
Place the electric switch easily accessible from the operator. If a plug contact is used in the
installation the wall socket shall be placed easily accessible from the operator.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
11.1
Mains connection
Alt. 1
a
Disconnect the mains power.
b
Connect the adaptor to the CU. (Use the power adaptor holder or the extension power cord if needed.)
c Connect mains power to the adaptor.
To Next Page
Loading...
