Envent 331S - Warranty & Liability Statements; Limitation of Warranty

Envent Engineering Ltd. Page 2 Revision 2.4
China Office:
Tel: (86) 138 - 0119 - 1148
For further information on our products and most updated manuals/product catalog
please visit: www.envent-eng.com
Warranty & Liability Statements
Products manufactured and supplied by Envent Engineering Ltd unless otherwise
stated are warranted against defects in materials and workmanship for up to 18
months from the date of shipment or 12 months from date of start-up, whichever
occurs first. During the warranty period the manufacturer will, as its option, either
repair or replace products, which prove to be defective.
The manufacturer or its representative can provide warranty service at the buyer's
facility only upon prior agreement. In all cases the buyer has the option of returning
the product for warranty service to a facility designated by the manufacturer or its
representatives. The buyer shall prepay shipping charges for products returned to a
service facility, and the manufacturer or its representatives shall pay for return of the
products to the buyer. The buyer may also be required to pay round-trip travel
expenses and labour charges at prevailing labour rates if warranty is disqualified for
reasons listed below.
Limitation of Warranty
The foregoing warranty shall not apply to defects arising from:
• Improper or inadequate maintenance by the user;
• Improper or inadequate unpacking or site preparation/installation;
• Unauthorized modification or misuse;
• Operation of the product in unfavorable environments, especially high
temperature and/or high humidity;
• Corrosive or other damaging atmospheres or otherwise outside published
specifications of analyzer.
Envent Engineering Ltd carries no responsibility for damage cause by transportation
or unpacking, unless otherwise specified in the incoterms.
Extended warranty may be available with certified start-up. Contact Envent
Engineering Ltd for details.
Envent Engineering Ltd reserves the right to change the product design and
specifications at any time without prior notice.