5. Planning of Microinverter Installation
5.1 Symbols on Inverter
5.2 Accessories
PV Module Module
AC Extension Cable
connectors(Optional)
To connect the AC side to
the grid.
AC End Cap
To seal the end of unused
AC cable.
5.3 Cable Model Selection
To install the AC Bus Cable, you just simply unroll the cable to the needed length
to make the cut. Directly connect the AC Bus Cable to the junction box of the
branch. Seal the other cutting end with the end cap to make it isolated from the
environment. You should choose the type of AC Bus Cable according to the
orientation of PV module. We suggest the following type of cable:
Symbol
Description
Dangerous electrical voltage
This device is directly connected to public grid,
thus all work related to the inverter shall only be
carried out by qualified person
NOTICE, danger!
This device directly connected with electricity generators
and public grid
Danger of hot surface
The components inside the inverter will release a log of
heat during operation. DO NOT touch aluminum casing
during operating.
An error has occurred
Please go to Chapter 10 “Trouble Shooting” to repair the
error.
This device SHALL NOT be disposed of in residential waste.
Please go to chapter 9 “Recycling and Disposal” for proper
treatments.
No unauthorized perforations or modifications
Any unauthorized perforations or modifications are
strictly forbidden. If any defect or damage
(device/person) is occurred, Envertech shall not take
any responsibility for it.
To Next Page
Loading...
Need help?
General
