7/8/2004
SAFETY PRECAUTIONS
Please read these instructions before assembling or operating this outdoor cooking appliance.
The ENVIROGRILL BISTRO is designed for outdoor use only.
The ENVIROGRILL gas barbecue must be installed and operated in accordance with the installation requirements
of your local gas supply authority or the appropriate installation code in the area of installation.
In the absence of local codes with either the National Fuel Gas code, ANSI Z223.1, or CAN/CGA-B149.1,
National gas Code or CAN/CGA-B149.2, Propane Gas Code..
If an external electrical source is utilized, this gas grill, when installed must be electrically grounded in
accordance with the local codes or, in the absence of local codes, with the National Electrical Code ,
ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.
Keep electrical cord and the fuel source hose away from any heated areas.
This outdoor gas grill is not intended for use in or on recreational vehicles and or boats.
Operate this gas grill only in areas free of obstructions for combustion and ventilation air.
The exterior surfaces of this gas grill can become very hot when is use. Exercise caution Use protective gloves
and or pot holders.
DO NOT USE THIS APPLIANCE IN AN ENCLOSED AREA,
For example Garages, sheds or enclosed sundecks or any other enclosed areas. Do not use this Gas Grill
under overhead, unprotected combustible materials such as awnings or umbrellas.
KEEP CHILDREN AWAY.
Do not allow children to operate this appliance. Keep children and pets away from barbecue during use, wait
until the appliance has completely cooled.
CHECK FOR GAS LEAKS.
Once the barbecue has been assembled and installed, make sure the gas valves are in the “OFF” position. Turn
gas “ON” at the source. Use a small brush to apply a warm soapy water solution to all gas connections. (use a
half dish soap and half warm water). If a gas leak is present, bubbling will occur. Gas leaks can be repaired by
using an approved pipe thread sealant or approved Teflon tape. The flexible gas hose must be inspected before
each use.
NEVER USE A NAKED FLAME FOR TESTING LEAKS.
LPG GAS CYLINDER.
Shut off
valve
Collar
An approved 20 lb. gas cylinder is required for optimum performance
and convenience.
LPG gas cylinder is not provided with this appliance. When
purchasing a LPG cylinder, make sure the cylinder has a manual shut
off valve. Also ensure that the cylinder has a collar to protect the
manual shut off valve.
LPG gas cylinder must be constructed and marked in accordance
with specifications of the U.S. Department of Transport (DOT). In
Canada gas cylinders must meet Canadian Transportation and
Communications (C T C) specifications.
NEVER CONNECT AN UNREGULATED LP GAS CYLINDER TO
YOUR BARBECUE.
DO NOT SUBJECT LP GAS CYLINDERS TO EXCESSIVE HEAT.
WHEN THE APPLIANCE IS NOT USE, THE GAS SUPPLY SYSTEM MUST BE TURNED “OFF” AT THE
SOURCE.
KEEP APPLIANCE AWAY FROM ANY COMBUSTIBLE MATERIALS.
VISUALLY INSPECT THE RUBBER GAS HOSE AND CONNECTIONS AND BURNERS ON A REGULAR
BASIS TO INSURE NO DAMAGE OR DETERIORATION IS PRESENT.
3
To Next Page
Loading...
Need help?
General
