5
Installation
DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:
Figure 1: Removing Freestanding Stove From the Pallet.
1. Check clearances to combustibles (see INSTALLATION - CLEARANCES TO COMBUSTIBLES
and INSTALLATION - ALCOVE CLEARANCES).
2. Do not obtain combustion air from an attic, garage or any unventilated
space. Combustion air may be obtained from a ventilated crawlspace.
3. Do not install the stove in a bedroom.
4. You can vent the stove through an exterior wall behind the unit or connect
it to an existing masonry or metal chimney (must be lined if the chimney
is over 6” (15 cm) diameter, or over 28 inches² (180 cm²) cross sectional
area). An interior vent can be used with approved pipe passing through the
ceiling and roof.
5. Locate the stove in a large and open room that is centrally located in the
house. This will optimize heat circulation.
6. The power cord is 8 feet (2.43 m) long and may require a grounded extension
cord to reach the nearest electrical outlet.
REMOVING PELLET STOVE FROM PALLET:
Remove screws from the two (2) hold-down brackets that secure the Empress to the pallet. Lift the
brackets up to unhook from the chassis.
To Next Page
Loading...
Need help?
General
