Enviro retreat - Cleaning Decorative Surfaces; Glass Door Removal

10
Maintenance And Service
CLEANING DECORATIVE SURFACES:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the
nish, including cleaners, polish and nger prints. It is important to note that ngerprints and other
marks can leave a permanent stain on plated nishes. To avoid this, give the face a quick wipe with
denatured alcohol on a soft cloth BEFORE lighting the replace. Never clean the face when it is
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into
the surface.
GLASS DOOR REMOVAL:
In order to install the log set, and
for regular cleaning, the glass door
must be removed. There are two
(2) door latch mechanisms under
and two (2) above the glass door
shown in Figure 6 & 7. Each latch
has two (2) nger grooves, use
these to pull the mechanisms
straight out. When the latches
are unhooked, lift the door up and
forward off the unit.
To replace the glass door, simply
reverse the above procedure.
Warning: Do not touch or attempt
to remove the glass if the replace
is not completely cold.
WARNING: Never operate
the replace with the glass
removed.
Figure 6. Bottom latches for glass door, disengaged.
Figure 7. Top latches for glass door, engaged.