33
Figure 53. Ceramic Liner Support.
Secondary Installation
Figure 52. Retreat complete log set-up with embers burning.
Never operate the replace with the glass door removed.
INSTALLATION OF CERAMIC FIREBOX LINER:
Turn off the gas control knob and allow the unit to cool.
Figure 52 shows The Retreat burning with a
good ame.
NOTE: While the glass is still removed, it is
recommended that the gas line be purged by
lighting the pilot.
When lighting the replace for the rst time
since the log set and embers have been
installed/replaced, watch for ignition at ALL
the burner ports. If a long delay is noticed,
turn the appliance off and wait for it to cool
down. Then remove the glass and rearrange
the ember material, ensuring none of the
burner ports are densely blocked.
Maintenance: Once a year, the charcoal
pieces and logs should be removed and
checked for deterioration or large amounts of
soot. A small amount on the bottom side of
the logs is normal. Remove and replace the
logs in the same manner described above.
If new/more rock wool embers are required,
contact your nearest ENVIRO dealer.
NOTE: The ceramic liner is fragile and
should be handled gently. Please ensure that
it has not been damaged.
To install the liner:
1. Remove the glass door by following the
instruction in the “S
ECONDARY INSTALLATION
- G
LASS DOOR REMOVAL” section and remove
logs if necessary.
2. A ceramic liner support must be in place
around burner (shown with a white outline in
Figure 53).
To Next Page
