21
English
Using Your Eos System Using Your Eos System
Adding a Receiver/Speaker to a System with a Unique ID
Once a unique ID is set on your Converge Transmitter, you will need to do the following to link
additional speakers to your Converge Transmitter: Please note - this procedure is only neces-
sary if you have set a unique ID for your Converge Transmitter.
Turn the power OFF on the Converge Transmitter1.
Turn OFF power to the Wireless Receivers/Speakers that you wish to link.2.
Turn the power ON on the Converge Transmitter3.
Press and hold the “LINK” button on the bottom of the Converge Transmitter for 4. 8
seconds until the Antenna LED starts blinking and then release button.
Turn on the Wireless Speaker/Receivers that you wish to link to this Converge Trans-5.
mitter one at a time within 60 seconds of pressing the “LINK” button.
Note: When Link button is pressed and held, the “Antenna link LEDs” on the Converge Trans-
mitter will blink slowly for a few seconds and then go to a fast blink (fast blinking indicates the
Converge Transmitter is in “Add a Speaker Mode”)
Resetting the ID to Default
To reset the Converge Transmitter and Receiver/Speaker’s ID back to the factory default, do the
following:
Turn OFF power to the Converge Transmitter1.
Turn OFF all power to the Wireless Receivers/Speakers. 2.
While pressing and holding the “LINK” button on the bottom of the Converge Transmit-3.
ter, press the Power ON button on the Converge Transmitter. Continue to hold the “LINK”
button for about 3 seconds until the Antenna Mast LED begins to ash.
Release “LINK” button4.
Turn ON the Wireless Receivers/Speakers within 60 seconds of releasing the “LINK” button.5.
Note: Allow each Wireless Receiver/Speaker to Link before turning on the next Wireless Speaker/Receiv-
er. After completing steps 1-5, speakers will be set to the factory default ID and will be able to link with
your Converge Transmitter or any other Converge Transmitter with the factory default ID in the vicinity.
To Next Page
Loading...