EOS Converge - Stereo System - Non USB Connection; Stereo System;Amplifier Connection

To Next Page

To Previous Page

English

Stereo System - Non USB Connection

By using the included power supply, the Converge Transmitter can function without

connection to the USB port of a computer.

A home stereo system may be connected by plugging in the supplied stereo headphone cable

to the jack on the Converge Transmitter marked AUX IN. The other end of the cable can be

connected to the headphone jack of the Stereo Receiver/Amplier using a headphone jack

adapter (not supplied). Output from the stereo system will be broadcast to all Eos receiver/

speakers. In this conguration only the AUX IN function is supported.

Stereo System Connection

The diagram below shows the connection using the stand-alone, non-USB connection to a

stereo receiver/amplier.

Note - When connected to the line output of a Stereo System, the Volume output from

the system has no eﬀect on the output level of the Converge Transmitter.

Converge Transmitter

TRANSMITTER

INPUTS OUTPUTS

STEREO RECEIVER/AMPLIFIER