20
English
Wireless Receivers/Speakers ID Settings
All Eos Converge Transmitters, Wireless Speakers and Receivers have the same ID setting. This
is done so Receivers/Speakers will automatically link with any Converge Transmitter. The Con-
verge Transmitter will link with the rst 4 Wireless Receivers/Speakers that it detects.
Linking Wireless Receivers/Speakers to a Specific Converge Transmitter
Due to the incredible range of the Eos system, it is possible for your speakers to receive audio
from a neighbors system. If this happens, or if you wish to run more than one Eos Wireless
System in your house, you can give your Converge Transmitters and the Receivers/Speakers
a unique ID. In giving your system a unique ID your Receivers/Speakers will link only to the
Converge Transmitter that they are paired to.
Setting a Unique ID
To give your Converge Transmitter and Receivers/Speakers a Unique ID, do the following:
Turn the power OFF on the Converge Transmitter1.
Turn OFF all power to the Wireless Receivers/Speakers that you wish to link. 2.
Turn the power ON on the Converge Transmitter3.
Press and hold the “LINK” button on the bottom of the Converge Transmitter for 4. 3
seconds until the “Link LEDs” on the Antenna mast starts blinking.
Turn on the Wireless Receivers/Speakers that you wish to link to this Converge Trans-5.
mitter within 60 seconds of pressing the “LINK” button.
Note: to link additional speakers once a unique ID has been set, refer to the “Adding a Speaker to a
System with a Unique ID” section on the following page.
Using Your Eos System Using Your Eos System
To Next Page
Loading...