Epelsa ECO MULTIFUNCTION - Manual Level and Part Counting Introduction

14
GBU-ECO-MF-V01
6.2. MANUAL LEVEL
To enter a Level value manually, press the key from the basic work mode with Levels:
Pressing the key repeatedly, you will cycle through the Over, Under and Target
values.
The values are entered using the numeric keypad and, when all the values
have been programmed, confirm by pressing the key.
7. BASIC MODE PART COUNTING
In this work mode, it is possible to work with Semi-Automatic Tare and Coded Numeric Tare.
The procedure is similar to that explained in the basic mode Weight-Tare. It is not possible to mix tares,
i.e., if there is a prior Semi-Automatic Tare, it is not possible to perform a numeric tare, and vice-versa.
      
0.000
0.700
Max 15 kg
Min 100 g
e= 5 g
I I I
kg
kg
Pcs
T
PT
0.000
UNDER
LEVEL
Max 15 kg
Min 100 g
e= 5 g
I I I
kg
kg
Pcs
T
PT
→0←