Epever MT50 - Device Parameter

27
4. Time control
Working time1
(T1)
Control on/off time of the load
through real-time clock mode.
Working time 1 is the
compulsory load working time
interval. Working time 2 is
optional.
Working time2
(T2)
Realize the dual timer function of the
load control through real-time clock
mode.
4.8 Device parameter
The solar controller's software version could be checked via the device parameter
page. And device data like device ID, device LCD backlight time, and device clock
could also be checked and modified. The device parameter page shows in the diagram
below:
Note: the bigger the connection device's ID value, the longer the communication
identification interval will be (the maximum interval<6 minutes).
Device Parameter
Ver: V01.00+V02.10
ID: 001
Device Parameter
Bklight:60S
Jan-01-2013
00:01:39