Epever MT75 - Button Instruction

9
7. Button Instruction
Button
Operation
Instruction
Click
Display PV parameters in cycle
Click
Display battery parameter in cycle
Click
Display load parameter in cycle
Exit the fault page
Press for 5S
Check error code information
Click
Control the switch of solar controller
and inverter in sync
①
Press for 5S
Clear the total of PV generated power,
total DC load usage, and total AC load
usage
① When the solar controller and inverter's output is out of sync, click to turn off
all the loads' output simultaneously, click again to turn on all the load outputs.