What to do if the fault red LED is on in Epever SHI2000?
If the fault red LED is constantly on your Epever Inverter, it indicates an abnormality. First, disconnect all plugs and restart the device. If it functions correctly afterward, inspect the load and wiring. However, if the red LED persists, the inverter has internal issues and should be returned to the factory.
What to do if load LED blink and fault red LED fast blink on Epever SHI2000?
If the load LED is blinking and the fault red LED is blinking rapidly on your Epever Inverter, it means there's an overload or a short circuit in the load. Verify that the AC load is within the rated power limits and check for any load shorts.
Why is the fault orange LED fast blinking on my Epever SHI2000 Inverter?
If the fault orange LED is blinking rapidly on your Epever Inverter, it indicates that the inverter is overheating. To resolve this, improve ventilation by ensuring that the vents are not blocked. Allow the inverter to cool down before restarting it.
What to do if the fault orange LED is on in Epever SHI2000 Inverter?
If the fault orange LED is on your Epever Inverter, it signals an abnormal condition. Ensure the DC input terminals are securely tightened and that the input voltage is between 21.6V and 30V (or 43.2~60V for 48V products). Then, restart the inverter. If the orange LED remains lit, the inverter has internal faults and should be returned to the factory.
How to fix input LED blink and fault red LED slow blink on Epever SHI2000 Inverter?
If the input LED is blinking and the fault red LED is blinking slowly on your Epever Inverter, it indicates that the input voltage is either too high or too low. Measure the input voltage to confirm. The inverter should return to normal operation once the input voltage is within the correct range.
General| Model | SHI2000 |
|---|---|
| Rated Power | 2000W |
| Surge Power | 4000W |
| Cooling Method | Fan cooling |
| AC Output Voltage | 230V |
| AC Output Frequency | 50Hz/60Hz |
| THD | <3% |
| Protection Features | Overload, Over temperature, Short circuit, Low voltage, Over voltage |
| Operating Temperature | -20°C to +50°C |
| DC Input Voltage | 12VDC / 24VDC / 48VDC |
To Next Page