What to do if the Load LED blinks and the fault red LED blinks fast on my Epever Inverter?
If the Load LED is blinking and the fault red LED is blinking rapidly, it indicates an overload or a short circuit in the load. You should verify that the AC load is within the inverter's rated power capacity and check for any load shorts.
Why is the fault orange LED blinking fast on my Epever Inverter?
A rapidly blinking orange fault LED indicates that the inverter's internal temperature is too high. To resolve this, improve ventilation around the inverter, ensuring that the vents are not blocked. Allow the inverter to cool down before restarting it.
How to fix Input LED blinking and fault red LED slow blinking on Epever Inverter?
The Input LED blinking along with a slow blinking red fault LED indicates that the input voltage is either too high or too low. Measure the input voltage, and the inverter should return to normal operation once the input voltage is within the correct range.
What to do if the fault red LED is on in my Epever Inverter?
If the fault red LED is continuously illuminated, disconnect all connected plugs and then restart the inverter. If it operates correctly afterward, inspect the load and wiring. If the red LED remains on, it suggests an internal fault, and the inverter should be returned to the factory.
General| Model | STI200 |
|---|---|
| Rated Power | 200W |
| Input Voltage | 12V DC |
| Output Frequency | 50Hz / 60Hz |
| Output Waveform | Pure Sine Wave |
| Peak Power | 400W |
| Cooling | Fan Cooling |
| Rated Output Power | 200W |
| Efficiency | 90% |
| Nominal Input Voltage | 12V DC |
| No Load Current | <0.4A |
| Protections | Overload, Over temperature, Short circuit |
| Operating Temperature | -20°C to +50°C |
| Storage Temperature | -30°C to +70°C |
To Next Page