What to do if the red indicator is fast flashing and the buzzer sounds on my Epever IP350-11?
If the red indicator is fast flashing and the buzzer sounds, it indicates a short circuit. Carefully check the load connections, clear the fault, and then restart the inverter.
What to do if the red indicator is slowly flashing and the buzzer sounds on my Epever IP350-11 Inverter?
If the red indicator is slowly flashing and the buzzer sounds, it indicates an overload. To resolve this, reduce the number of AC loads and then restart the inverter.
Why is the green indicator fast flashing and the buzzer sounding on my Epever IP350-11?
The fast flashing green indicator and buzzer sound indicate a DC input overvoltage. Measure the DC input voltage; if it's higher than 16/32/64V, adjust the input voltage to restore normal operation.
How to fix the Epever IP350-11 Inverter when the green indicator is slowly flashing and the buzzer sounds?
A slowly flashing green indicator and a sounding buzzer indicate DC input under-voltage. Measure the DC input voltage. If the voltage is lower than 10.8/21.6/43.2V, adjust the input voltage to restore normal operation.
Why is the red indicator slowly flashing and the buzzer sounding on my Epever Inverter?
If the red indicator on your Epever Inverter is slowly flashing and the buzzer is sounding, it usually means there's an overload. To fix this, try reducing the number of AC loads connected to the inverter. If the problem continues, restart the inverter.
What does it mean when the green and red indicators are solid and the buzzer sounds on my Epever Inverter?
When both the green and red indicators are solid and the buzzer sounds on your Epever Inverter, it signals an over-temperature condition. The inverter will automatically stop output when the heat sink temperature exceeds 80°C or the internal temperature goes above 60°C. The inverter will resume output when the heat sink temperature drops below 70°C and the internal temperature is below 50°C.
How to fix a green indicator that is fast flashing with a buzzer sound on my Epever Inverter?
If the green indicator on your Epever Inverter is flashing rapidly and the buzzer is sounding, it indicates a DC input over voltage. Measure the DC input voltage. If it's higher than 16/32/64V, adjust the input voltage to restore it to the normal range.
What to do if the green indicator is slowly flashing and the buzzer sounds on my Epever Inverter?
If the green indicator on your Epever Inverter is flashing slowly and the buzzer is sounding, it means the DC input voltage is too low. Measure the DC input voltage. If the voltage is lower than 10.8/21.6/43.2V, adjust the input voltage to restore normal operation.
General| Model | IP350-11 |
|---|---|
| Rated Power | 350W |
| Input Voltage | 12V DC |
| Output Voltage | 220V AC |
| Output Waveform | Pure Sine Wave |
| Efficiency | ≥90% |
| Cooling | Fan cooling |
| Weight | 1.5 kg |
| Output Frequency | 50Hz |
| Protection | Overload, Short circuit, Over temperature |
| Operating Temperature | -20°C to +50°C |
To Next Page
