Epever STI200 - Inverter Operation

4
3. Inverter Operation
Connect the input and output terminals accurately. Turn on the
power using the ON / OFF switch on the front panel. In order to avoid the
protections resulted from the surge power, please turn on AC loads one by
one after the output of the inverter is normal. Please check it as below:
 Set the power switch to the „OFF‟ position.
 Insert the load‟s plug into the inverter‟s output outlet.
 Connect the battery („+‟ terminal with red line, „-‟with black line). Do
not connect them by contraries, or the power inverter will not work.
 Switch the inverter to ON and then turn on the loads one by one.
Check the operation state of both power inverter and loads. „Green‟
of the failure LED indicator means the state is normal.
 If there are different loads, it is suggested that turn on the load with
large startup current first, such as television, then turn on the load
such as lamp when the inverter works stable.
 If the failure LED indicator is „Red‟ and the buzzer alarms or no
output when you turn on devices, switch off the loads and power
inverter immediately. Check the system by referring to the
troubleshooting guide. Turn on the devices again according to the
operation methods after the failure is removed.