What to do if the Epever TRIRON2210N Controller is not working even when the wire connection is correct?
If your Epever Controller isn't working despite correct wire connections, the battery voltage may be too low. Ensure the battery voltage is at least 9V to activate the controller.
Why is the charging LED indicator off on my Epever Controller during the day with proper sunshine on the PV modules?
The charging LED indicator might be off because of a PV array disconnection. Confirm that the PV and battery wire connections are correct and tight.
General| Model | TRIRON2210N |
|---|---|
| Rated Voltage | 12V/24V Auto |
| Rated Charge Current | 20A |
| Rated Load Current | 20A |
| Max PV Input Voltage | 100V |
| Communication | RS485 |
| Self-consumption | ≤ 10 mA |
| Temperature Compensation | -3mV/°C/2V(Default) |
| Charge Circuit Voltage Drop | ≤0.26V |
| Discharge Circuit Voltage Drop | ≤0.15V |
| Type | MPPT |
| Max PV Input Power | 260W(12V) / 520W(24V) |
| Grounding | Negative |
| Protection | Short Circuit, Reverse Polarity |
| Battery Type | Sealed, Gel, Flooded |
Provides a general overview of the TRIRON series MPPT solar charge controllers.
Lists critical safety warnings and general advice for installing the solar charge controller.
Covers supported battery types, local, and remote settings for battery parameters.
Describes the various built-in protection functions of the controller against electrical faults.
Provides solutions for common issues and error indicators encountered with the controller.
To Next Page