Why is the charging indicator on my Epever Controller flashing green rapidly?
A rapidly flashing green charging indicator on your Epever Controller indicates a battery over voltage. Check if the battery voltage is higher than the over voltage disconnect voltage (OVD) and disconnect the PV.
What does it mean when the battery indicator on my Epever XTRA N Controller is flashing red slowly?
A slow flashing red battery indicator on your Epever Controller indicates that the battery is overheating. The controller will automatically turn the system off. When the temperature declines to be below 55 ºC, the controller will resume.
General| Efficiency | ≤98% |
|---|---|
| Temperature Compensation | -3mV/°C/2V (Default) |
| Communication | RS485 |
| Battery Type | Sealed, Gel, Flooded |
| Protection | PV Reverse Polarity |
Provides essential safety and general notes for installing the solar charge controller.
Specifies requirements for PV array configuration.
Details recommended wire sizes for PV, battery, and load connections.
Details various protection mechanisms like over-current, short-circuit, and overheating.
Provides solutions for common faults related to PV array, battery voltage, and load.
To Next Page