30
AIR FLOW CONTROL
You can control the air flow by adjusting the air louver to a specific position or for
continuous oscillation.
To adjust, press once the Medium Fan button, then press and hold the Medium
Fan button, the Air Flow Symbol will be lit in red, the louver will move gently.
Keep holding the Mediun until louver is in the desired position.
When the desired position is reached, release the button.
ATTENTION
In cooling and dehumidification modes, the position
of the air louver is reset every 30 minutes to prevent
condensation from forming.
CAUTION
Do not adjust the air louver manually as it can damage
the louver motor.
FAN SPEED
Pressing the appropriate fan speed buttons will change the speed of the fan in cooling and
heating modes. You can choose three fan speeds or automatic.
In Automatic Mode - shown by a lit-up “A” the onboard microprocessor automatically adjusts
the fan speed as needed. The speed will always be automatically increased and decreased
as the room temperature approaches the set temperature.
To enable the quietest fan speed, ideal for nighttime, press the silent fan button
To enable the medium fan speed, press the medium fan button
To enable the maximum fan speed, press the maximum fan button
To activate Auto Mode, press the Auto Fan button
To Next Page
Loading...
Need help?
General