Epilog Laser Fusion Pro 32 User Manual

3. Descriptive Label: This label identifies the classification of the
Model 16000 in accordance with 21 CFR 1040.10 and IEC 60825-1. It is
located on the right side of the machine’s cabinet, below the
Warning Logotype.
4. Non-interlocked Protective Housing Safety Labels: These labels
are located on, or adjacent to, removable access covers on the
machine’s cabinet as shown in the diagrams to follow. Where a
label is located on a removable cover, there is an additional label
under the cover so that it will be visible when the cover has been
removed.
5. Defeatably-interlocked Protective
Housing Safety Labels: There is one
label on each of the machine’s
cabinet doors; one on the front
door and one on the top door.
6. Emergency Stop Label: This label is
located below the red Emergency
Stop switch on the top right side of
the machine.
7. Electrical Safety Label: This label is
located on the back of the machine
in the lower le-hand corner.
8. Main Breaker Label: This label is
located on or above the power
module panel at the right side of
the machine’s cabinet.
9. Aperture Safety Label: This label is
located above the aperture, inside
the cabinet, where laser beams
enter the machine’s engraving
area.
10. Power Labels: The appropriate
label for the machine is located on
or below the power module panel
at the right side of the machine’s
cabinet.
11. Fire Warning Label: There are two
labels on top of the machine’s cabinet; one to the le and one to
the right of the top cabinet door.
3
11
4
5
6
7
8
9
10
- 6 -
SECTION 1: SAFETY

Epilog Laser Fusion Pro 32 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 32
Category	Engraver
Language	English