Epilog Laser Fusion Pro 32 User Manual

7. Select “Focus Commands” from the menu.
8. Select “Calibrate CO2 Focus”. Ensure the
material thickness used during calibration is
entered in the Thickness text box (The default
of 0.025” corresponds to the supplied
anodized aluminum). Press “Start”.
9. Once the calibration is complete, press
“Done.”
10. The CO2 auto focus should now be
calibrated properly, and you will now need
to calibrate the Auto Focus Plunger. See
“Calibrating the Auto Focus Plunger” on
page 226.
- 222 -
APPENDIX C: SYSTEM CALIBRATION

Epilog Laser Fusion Pro 32 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 32
Category	Engraver
Language	English