Epilog Laser Fusion Pro 32 User Manual

7. Select “Focus Commands” from the menu.
8. Select “Calibrate Fiber Focus”.
9. Press “Start” to calibrate, and then press
“Done” when completed.
10. Back at the Focus Commands menu, select
“Calibrate CO2 Focus”. This will reset the CO2
focus height, allowing proper CO2 focus
adjustment in the following steps.
11. Press “Start” to calibrate, and then press
“Done” when completed.
- 224 -
APPENDIX C: SYSTEM CALIBRATION

Epilog Laser Fusion Pro 32 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 32
Category	Engraver
Language	English