Epiroc SBU 160 - User Manual

Questions and Answers

P
Paula CochranAug 12, 2025
What to do if my Epiroc Construction Equipment hydraulic breaker does not start?
- M
  murphygrantAug 12, 2025
  If your Epiroc Construction Equipment hydraulic breaker isn't starting, several issues could be the cause. First, ensure the pressure and tank hoses aren't mixed up. Next, check that the shut-off valves in the pressure and tank hoses are fully open. Also, inspect the couplings for defects that might be blocking the hoses and replace any defective coupling valves. Furthermore, verify that the operating pressure isn't too low and that the return pressure isn't too high. Adjust settings or replace defective parts as needed.
A
Amber MeyersAug 22, 2025
Why is my Epiroc Construction Equipment hydraulic breaker operating too slow?
- M
  mooregabrielAug 22, 2025
  If your Epiroc Construction Equipment hydraulic breaker is operating too slowly, there are several potential causes. Begin by checking if there's insufficient hydraulic oil delivery volume, and adjust the engine speed or mode stage of the carrier and the operation pressure. Inspect the valves in the pressure and tank hoses to ensure they are fully open. Also, examine the oil filter and oil cooler for high flow resistance, cleaning or replacing them as necessary. Finally, check if the working tool is jammed in the lower breaker part and correct the direction of the carrier boom.
M
Michele Reed DVMSep 1, 2025
How to fix low impact force on Epiroc Construction Equipment?
- I
  iandersonSep 1, 2025
  If the impact force is too low on your Epiroc Construction Equipment, it may be due to low gas pressure or whipping and pulsing hoses. Check the gas pressure and fill the accumulator.