31
Installation
Concentrator plus/Vacufuge® plus
English (EN)
4.3.4.1 Connecting a vacuum pump up to 350 W
Prerequisites
•Power consumption of the vacuum pump: max. 350 W or connected electrical load max. 400 VA.
•Special plug for control and power supply of the vacuum pump (see Accessories on p. 58).
•1 connecting hose (length: max. 50 cm, inner diameter: 8 mm, chemical resistant and suitable for
vacuum applications).
Abb. 4-4: Special plug for control and power supply of a vacuu m pump with a power consumption of up to 350 W.
Fig. 4-4: Special plug for control and power supply of a vacuum pump with a power consumption of up
to 350 W.
Vacuum pumps which meet these requirements can for example be diaphragm or rotary vane
pumps. The specifications can be found in the vacuum pump's technical data or requested
from the manufacturer. If you have any other questions regarding the correct operation of the
vacuum pump, e.g., handling, use, performance, service, troubleshooting or specification and
connecting a cold trap, please also contact the manufacturer.
Should you encounter any problems when connecting the vacuum pump, please contact
Technical Service. The contact addresses can be found on the Internet at
www.eppendorf.com
.
To Next Page
Loading...