34
7 Programming
Changing the program line
– Using the keys, move the flashing cursor onto the parameter which is to be changed.
– Enter data using the digit block
or select between settings using the key or
enter letters using the key.
Inserting a program line
– Move the flashing cursor in front of the line.
The cursor must be positioned on the program line number.
– Press the
key. A new line is inserted
above
the cursor.
– Select the command using the key.
Note:
Press the key for options regarding the temperature command.
In this case, the cursor must be positioned on the program line number in front of the temperature
command.
Deleting a program line
– Move the flashing cursor to the program line number.
– Press the
key. The line is deleted.
– After a program has been changed, exit the "Edit" processing level by pressing the key.
– Confirm the safety check "Save:YES" by pressing .
– The program can be saved using the same name.
Confirm the check "Overwrite:YES" by pressing .
– If the program should not be overwritten, and a new program is to be created, answer "Overwrite:" with
"NO" ( and keys) and enter a new program name.
Changing and checking programs
– Load the program that is to be changed / checked ("Load" menu; the program name must be in the
bottom left in the processing level).
– Change the program.
– Exit the program using the key. "Program not saved – Save YES" appears in the display.
Either save the program or exit by pressing .
Caution:
If the changed program is not stored under a new name, there will be two different programs
with the same name. The program which has been changed is in the processing level and the program
which has not been changed is in the device memory.
– Start the program: Press the key. The program which has been changed starts running.
– Program end: "End of Program" appears in the display. Press the key.
– If you now want to save the program which has been changed, select the "Load" menu and press .
"Program not saved – Save YES" appears in the display.
– Save the program: Press .
/
To Next Page
Loading...