53
12 Troubleshooting
M
emoryCard
Read-Only!
Card is marked as write-protected. Card must be formatted.
Automatic procedure when program
is saved.
M
emoryCard
Write Err!
Writing error on card. – Insert card correctly
(check that card is facing in
correct direction).
– Do not touch/move card during
saving.
M
ID BLOCK
DEFEKTIV!
Defective regulator or electronics
on middle block.
Switch off device.
Contact SERVICE.
N
ame Invalid! Program name contains an
invalid character.
Enter program name again.
P
OWER ERROR! Voltage error or defective fuse. Contact SERVICE.
P
rinter: OFF LINE Printer is not ready to receive. Select the "ON LINE" printer setting.
P
rinter: no response No printer is available or the printer
is not switched on.
– Select "OFF" in the menu
OPTION/Printer/Print Protocol.
– Switch on the printer.
P
rogram is running! A program is being processed. Lid temperature cannot be modified
at the moment.
P
rogram too large! Program is too large. Max. 40 program lines possible.
R
estarting Program! A power failure occurs or the device
is switched off briefly when a program
is running.
The program continues automatically.
R
IGHT
BLOCK
DEFEKTIV!
Defective regulator or electronics
on right-hand block.
Switch off device.
Contact SERVICE.
S
LOWING DOWN! The heating rate or cooling rate
has slowed down.
If error recurs, contact SERVICE.
S
teps free Display of free memory spaces
is < 100 steps.
1 step = 1 program line.
Delete programs which are not
required or store them on the
personal card.
T
Sensor_Err – Permitted operating conditions
have not been maintained.
– Technical defect.
– Operate device at permitted
temperature and humidity only
– Contact SERVICE.
Error message Cause Solution
To Next Page
Loading...