Operation
Mastercycler
®
nexus
English (EN)
44
5.5.2 Copying folders and programs
To copy folders or programs into your own user node, proceed as follows. When copying a folder, the
programs it contains are also automatically copied.
1. In the user node of any user, mark the folder or program you want to copy.
2. Press the Copy softkey.
A message appears informing you that the folder or the program was copied to the clipboard.
3. Press OK to confirm the message.
4. Mark your own user node. If you want to copy an individual program, you can also select a folder under
your user node to which you want to copy the program.
5. Press the Paste softkey.
If a program or folder already exists with the same name, you will be prompted to enter a new name.
The folder or program is pasted below your user node. You can now start or edit this program.
5.5.3 Deleting folders and programs
1. In the navigation tree, mark the folder or the program.
2. Press the del key.
A confirmation prompt appears.
3. Press the Yes softkey.
The folder or program is deleted.
5.6 Using the schedule
The schedule enables users to reserve devices for a specific time. You can view the schedule at any time or
use it as an automatic screensaver. Use the System > Schedule Settings node to set the devices and
weekdays for the schedule. Past schedule entries are automatically deleted.
Mark the Eppendorf node. Press the Schedule softkey.
The Mastercycler Schedule window appears.
You can use the schedule as an automatic screensaver (see p. 70)
To Next Page
Loading...
