EasyManuals Logo

ePropulsion E Series User Manual

ePropulsion E Series
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
19
2.3.4 Charging the Batteries in Parallel
When connected in parallel, the CAN-IN port must be connected to a remote
switch or a communication terminator.
When charging parallel batteries, the charger should connect to a battery
whose CAN-OUT port is not connect with the E battery communication cable
(refer to the 2# battery in figure 2-7).
When charging parallel batteries, the charging time will be longer than charging
one battery. You can choose a charger with greater output power to charge the
parallel batteries to shorten the charging time.
When charging the parallel batteries, the operation is the same as charging the
battery. Please refer to 2.2.3 charging the battery.
Figure 2-7
CAN-IN CAN-OUTMOTOR
CAN-IN CAN-OUTMOTOR
Remote
Switch
1#Battery
2#Battery
Charger
Communication
Terminator
Battery Bridging
Cable
Battery Bridging
Cable
E battery
Communication Cable
Communication
Cable

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ePropulsion E Series and is the answer not in the manual?

ePropulsion E Series Specifications

General IconGeneral
BrandePropulsion
ModelE Series
CategoryCamera Accessories
LanguageEnglish