2. Hold down the
E
load/eject button for three seconds, the
print head moves to the replace position. The
P
power
light begins flashing.
3. Lift the ink cartridge clamp. Dispose of the ink cartridge
properly.
4. Remove the yellow tape seal from the new cartridge and
lower the cartridge into the cartridge holder.
5. Press the ink cartridge clamp down until it locks in place.
c
Caution:
Once you install the cartridge, do not open the clamp
again until you replace the ink cartridge. Otherwise, the
cartridge may become unusable.
6. Press the
E
load/eject button again. The printer moves the
print head back to its home position and charges ink in the
system.
c
Caution:
The
P
power light continues to flash while the printer
performs the ink charging operation. Never turn off the printer
while the
P
power light is flashing. Doing so can result in
incomplete charging of ink.
Note:
Even if you do not press the
E
load/eject button, the printer moves the
print head back to its home position about 60 seconds after you replace
the cartridge.
6
Troubleshooting
R
Hudson++ Ref. Guide
Rev.d
A5 size Chapter 6
04-30-98 DR, pass 3
Troubleshooting
6-23
To Next Page
Loading...
