EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 161
8.
Remove the PRINT HEAD from the CARRIAGE, ASSY., and disconnect the
HARNESS, HEAD, A/B from CN1 and CN2 connectors on the PRINT HEAD.
See Figure 4-93.
Figure 4-93. Removing the PRINT HEAD
C A U T I O N
Do not disconnect/insert FFCs from/into the connectors at an angle.
Doing so may damage, short, or break the terminals in the
connector resulting in a breakdown of the elements on the board.
A D J U S T M E N T
R E Q U I R E D
Whenever the PRINT HEAD is replaced,
the corresponding adjustments must be carried out.
See Chapter 5 "ADJUSTMENT" (p190).
HARNESS, HEAD, A/B
CN2
CN1
PRINT HEAD
To Next Page
Loading...
