EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 170
11. Remove the FFCs secured with the two-sided tape to the FRAME ASSY., SUB, RIGHT.
See Figure 4-108.
12. Remove the acetate tape shown in Figure 4-109.
13. Remove the five screws that secure the FRAME ASSY., SUB, RIGHT and remove it.
See Figure 4-108, 4-109.
Five C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
Figure 4-108. Removing the FRAME ASSY., SUB, RIGHT
Figure 4-109. Removing the screws from the FRAME ASSY., SUB, RIGHT
C H E C K
P O I N T
To remove/install the two of the five C.B.S. 3x6 screws, insert a
screwdriver through the holes on the FRAME, ASSY, SUB,
RIGHT shown in Figure 4-108.
Make sure to carry out the followings when installing the FRAME
ASSY., SUB, RIGHT to the main unit.
Be sure to align the seven positioning holes of the FRAME
ASSY., SUB, RIGHT with the seven ribs on the main frame.
After fastening the screws shown in Figure 4-109, be sure to
reattach the acetate tape, which is removed in step 11., to cover
the screw head and the rib so as not to damage the FFCs with
them.
C.B.S. 3x6
positioning points
Insert a screwdriver through those holes.
Right side of the printer
Two-sided Tape
FRAME ASSY., SUB, RIGHT
positioning points
C.B.S. 3x6
positioning points
acetate tape
C.B.S. 3x6
To Next Page
Loading...
