EPSON Stylus Pro 3800/3800C/3850 Revision A
ADJUSTMENT Standard Adjustment 219
ADJUSTMENT PROCEDURE
1. Turn the printer ON.
2. Start the adjustment program, and select [Colorimetric Calibration Tool].
3. Click [Run] to start the [Colorimetric Calibration Tool].
4. Load an A4-sized plain paper vertically on the ASF, and click [Next] to start the
alignment check.
5. Examine the printout. If any missing line or segment is observed, run a cleaning.
If the pattern is normal, click [Next].
6. Load an A4-sized EPSON Enhanced (Archival) Matte paper vertically on the
ASF, and click [Next] to print a calibration chart.
7. Make sure there is no missing dots in the nozzle check pattern at the bottom of the
calibration chart.
If there are missing dots, click [Print Calibration Chart Again]. The calibration
chart will be printed again after performing cleaning.
If there are no missing dots, let the chart stand for five minutes until it dries out
paying attention not to touch the chart.
8. When the calibration chart dries out (after five minutes), click [Next].
Figure 5-39. Screen Transition
C A U T I O N
Never touch the printed calibration chart.
To Next Page
Loading...
