78
❏ Printout has smears on the bottom edge
❏ Printing is too slow
Blank pages print
❏ Run the Head Cleaning utility to clear any clogged
nozzles.See “Cleaning the Print Head” on page 65.
Printout has smears on the bottom edge
❏ If the paper is curled toward the printable side, flatten it or
curl it slightly in the opposite direction.
❏ Set the adjust lever to the “+” position.
Printing is too slow
❏ Make sure that the Media Type setting in the Control Panel is
correct.
Paper Does Not Feed Correctly
If one of the following problems has occurred, try the solution(s)
listed for that problem.
❏ Paper does not feed
❏ Multiple pages feed
❏ The paper jams
❏ Paper is not ejected fully or is wrinkled
To Next Page
Loading...
