Item Settings (default in bold)
Extended Mode
Off, On
LCD Contrast
0 to 7 to 15
LCD Backlight
*4
Auto, Off
RAM Disk
*5
Off, Normal, Maximum
Convert to Simplex
Odd Page, 1 Page, Off
Confirm Media Type
No, Yes
Job Info. Display Pattern 1, Display Pattern 2, Off
*1
Available only when you use A4, A5, B5, LT, HLT, LGL, GLT, GLG, EXE, or F4 size paper.
*2
Available only for ESCP2, FX, or I239X mode.
*3
Not available in PS3 and PCL.
*4
Available only forAL-M400 Series.
*5
After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again.
Language
Specifies the language displayed on the LCD panel and that printed on the status sheet.
Time Out
Specifies the length of the time, in seconds, before a time out when interfaces are being switched
automatically. The time before a time out occurs is the length of time from the point when no data is
being received from an interface until the point of switching the interface. If the printer has a print job
when switching the interface, the printer prints the print job.
MP Mode
This setting determines whether the MP tray has the highest or lowest priority when Auto is selected
as the Paper Source setting in the printer driver. When Normal is selected as the MP Mode, the MP tray
has the highest priority as the paper source. If you select Last, the MP tray has the lowest priority.
Manual Feed
Allows you to select the manual feed mode for the MP tray.
Copies
AL-M300/AL-M400 Series User's Guide
Using the Control Panel 70
To Next Page
Loading...
Need help?
General