Word Processing
ESC a
NLQ Justification
Format:
ASCII code:
ESC
a
n
Decimal:
27 a n
Hexadecimal:
1B 61 n
Comments:
The following values can be used for n:
0: Selects left justification.
1: Selects centering.
2: Selects right justification.
3: Selects full justification.
The default setting is n = 0. Full justification (n = 3) is performed
when the buffer becomes full or when one of the following is
received: CR, VT, LF, FE The commands HT and BS are invalid
except in n = 0 mode. For n = 3 there must be no carriage returns
within a paragraph. Justification can be used in NLQ only, not draft.
Character Sets
ESC t
Select Character Table
Format:
ASCII code:
ESC t n
Decimal:
27
116 n
Hexadecimal: 1B 74 n
Comments:
The following values can be used for
n:
0: Selects italic character set.
1: Selects Epson Character Graphics.
Selects which character table is to be used by codes 128-255.
Selecting Epson Character Graphics does not disable italic printing.
Italic printing can still be selected by ESC 4. Duplicates the function
of DIP switch 1-3. Note that the value of n must equal 00 hex or 01
hex; the characters “0” and “1” cannot be used.
A-26
Command Summary
To Next Page
Loading...
