116
11. To install a new separation roller, insert the end of the roller into the hole on the right side and lower
the other end of the roller into place.
12. Close the separation roller cover until you hear it click into place.
Note: If you are not able to close the cover, the roller is not installed correctly. Remove the roller and
reinstall it, then try to close the cover again.
13. Close the scanner cover.
14. Connect any disconnected cables.
15. Plug in the AC adapter and turn on the scanner.
16. Reset the roller counter.
Resetting the Scanner Roller Counter
Parent topic: Cleaning and Transporting Your Scanner
Resetting the Scanner Roller Counter
When you replace the scanner rollers, reset the scanner roller counter so you know when you may need
to replace the rollers again.
1. Press the OK button, if necessary.
2. Use the arrow buttons to select Scanner Maintenance and press OK.
3. Use the arrow buttons to select Roller Replacement and press OK.
To Next Page
Loading...
