Epson B11B259201 User Manual

1.
Access Web
Cong
and select the Scan tab > Document Capture Pro.
2.
Select Server Mode for Mode.
3.
Enter the address of the server with Document Capture Pro Server installed on it for Server Address.
Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you
can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the
address.
4.
Click OK.
e
network is re-connected, and then the settings are enabled.
Registering Preset or Quick Send Buttons
You can register up to 12 frequently used scanning setting as Preset.
Settings registered to the preset number 1 to 3 are assigned to the
(Quick Send) buttons on the scanner.
You can register the following destinations as Preset.
❏ Network folder
❏ Email address
Note:
Congure a network folder or email server before creating a preset.
1.
Access Web Cong.
“Running Web
Cong
on a Web Browser” on page 23
2.
Login as an administrator to change the scanner settings.
Click Administrator Login at the top-right of the screen. Enter the User Name and Current password, and
then click OK.
Note:
If Administrator Logout is displayed at the top-right of the screen, you are already logged in as an administrator.
3.
Select Scan tab > Presets.
4.
Select the Presets number you want to congure, and then click Edit.
5.
Select Type, and then click Next.
6.
Enter the name you want to display, and then click Select from Contacts or Enter Destination to set the
destination information.
You can enter the email address manually to add to the destination.
7.
If Scan to Email is selected as the Type , set the Email Settings.
8.
If Scan to Network Folder/FTP is selected as the Type, set the File Settings.
Preparing to Scan over a Network > Registering Preset or Quick Send Buttons
87

Epson B11B259201 Specifications

General

Brand	Epson
Model	B11B259201
Category	Scanner
Language	English