22
E Connect the power cable and other cables to the projector
Connect any necessary cables such as the power cable, computer cable, and USB cable to the projector.
If you are planning to run the cables inside the wall, make sure you follow all local electrical codes.
If you are running the cables outside the wall, use a cable management system to keep the cables
from obstructing the image. An optional cable management system is available from Epson
(part # ELPCK01).
6. Adjusting the Image
To ensure maximum projection screen quality, follow the steps below to adjust the projected image.
A Turn on the projector
Do not make adjustments with the Keystone function of the projector. Doing so may
result in a reduction in image quality.
Using Remote Control Using Control Panel
Power cable
Computer cable
USB cable
To Next Page
Loading...
