151
Troubleshooting
Printer maint.
error
Repair is required.
Please contact Customer Support.
Replace ink
(C,LC,LM,M,Y,K)
The ink in the cartridge is out.
Replace the cartridge of the displayed color. (See
“Changing the ink cartridge” on page 126 in this guide.)
Replace inkpad It is time to replace the ink pad.
Please contact Customer Support. The ink pad cannot be
replaced by the customer.
Stacker 3
installed
Remove Stacker 3, and close the disc cover. Stacker 3 is not
used in Standard Mode or External Output Mode (when
Stacker 4 is set as the output stacker).
Stacker 3
not installed
Load Stacker 3, and close the disc cover. Stacker 3 is used in
Batch Mode or External Output Mode (when Stacker 3 is set
as the output stacker).
Stacker 4 full The initialization operation cannot be performed because
Stacker 4 is full.
Remove the discs from Stacker 4.
Stacker 4 open Close Stacker 4.
Stacker full
ST2,ST3,ST4
The disc cannot be ejected because the output stacker is
full. Remove the discs from the output stacker (Stacker 2,
Stacker 3, or Stacker 4).
Too many discs
ST1,ST2,ST3
Remove excess discs so that the height of the discs in the
indicated stacker is below the red line of the stacker, and
then close the disc cover.
Transferred disc
detection error
A disc could not be detected after transfer to a printer or
drive. Turn off the power, and then turn it on again. If the
same error message still appears, repair is required. Please
contact Customer Support.
Wait a moment
and try again
Press the button or CANCEL button. Do not unlock the
disc cover repeatedly within a short time. Wait a moment
before unlocking.
Write error Processing of the job is paused. See “Disc writing problems”
on page 154 in this guide, and after removing the cause of
the error, restart the job. (See “Resuming jobs” on page 110 in
this guide for the job restarting procedure.)
Error Message Remedy
Notification
Sound
To Next Page
Loading...
Need help?
General
