12
Preparation
Preparation
Installation
Install this product in a suitable location with adequate space.
CAUTION
• Make sure that the product is lifted by two people.
• The weight of this product is approximately 26 kg. When this product is lifted, it should be
lifted on both sides by two people holding the recesses on the sides as shown in the
illustration on the left. Holding any part other than the ones indicated in the illustration on
the left when carrying the product may result in damage to the product. In particular,
carrying the product while the disc cover, ink cartridge cover, or Stacker 4 is open may
result in the product being dropped, or deformed and damaged.
Furthermore, when putting down this product, take care not to trap a finger between the
product and installation surface.
• When lifting this product, make sure that, for example, you sufficiently bend your
knees and your posture is such that excessive stress is not placed on your body.
An unnatural posture when lifting the product may result in an injury, or the product being
damaged.
• When moving the product, do not tilt it 10 or more degrees in a forward or backward
direction, or sideways direction.
The dropping or other mishandling of the product may result in an accident.
• Do not place a heavy object on the top of the product.
Subjecting this product to excessive force may result in a malfunction.
However, it is possible to place one unit of this product on top of another. In such a case,
make sure the tops and bottoms are oriented the same, and the exterior of the units are
aligned.
Take sufficient care to prevent a unit from dropping or falling. Also, do not place more
than one unit on top of another.
• In a location where static electricity is easily generated, use an antistatic mat and other
product to prevent static electricity.
• Do not install this product in locations with large amounts of dust, dirt, or cigarette smoke.
• Do not use or store in high-temperature, high-humidity environments. This can cause the
label surfaces to blur and stick together.
To Next Page
Loading...
